Development of urban construction is inseparable from reinforced concrete, so we are visible everywhere around the building of concrete, its scope is particularly wide, before we often see after concrete pouring will be covered with a layer of "quilt", in fact, its main purpose is to insulation for concrete curing. Because after concreting is needed to cover heat conservation, so as to prevent rapid evaporation of water in the concrete, the concrete in order to ensure a suitable temperature gradient. With the progress of society, temperature control technology is more and more intelligent, and concrete temperature control are controlled by Li Pu heat ce approved 1600kw steam generator with factory price. The initial temperature of the concrete casting is an important part of the concrete maximum temperature, cool down process for the concrete in a plastic state, while reducing the maximum temperature, the temperature is correspondingly reduced induced cracking of concrete. Thus, an effective conservation is one method to prevent cracking of concrete by vertical steam generator heat pump concrete in a plastic state.

Oil-fired boilers include oil-fired water boilers, oil-fired hot water boilers, oil-fired heating boilers, oil-fired bath boilers, oil-fired steam boilers and so on. Oil-fired boilers are boilers fueled by light oil (such as diesel oil, kerosene), heavy oil, residual oil or crude oil. Compared with gas-fired boiler and gas-fired boiler, oil-fired boiler runs more economically than electric heating boiler and is more convenient to use than gas-fired boiler. With the development of economy and social progress as well as the improvement of people's awareness of environmental protection, coal-fired boilers are gradually out of sight because of serious pollution. Instead, they are replaced by new types of environmental protection digital boilers, such as electric heating boilers and oil-fired boilers. Gas fired boilers, etc., electricity Heating boiler operation is the most expensive, gas-fired boiler needs to be opened with gas pipeline, then, if there is no natural gas pipeline, but also hope that the operation cost of the boiler is low, only the choice of fuel-fired boiler. Oil-fired boiler is heated by burners, fuel atomization effect is good, fuel combustion is full, chimney can not see black smoke, so fuel-fired boiler green environmental protection, efficient and energy-saving. After the fuel oil is sprayed into the furnace, it is very easy to mix with air and burn rapidly and exothermic rapidly. Compared with coal-fired boiler with the same parameters and capacity, the thermal strength of furnace volume can be doubled. However, in order to reduce the heat load in the combustor zone, the water wall tube in this zone is avoided. Because of the overtemperature, the furnace volume is only reduced by about 1 / 3. Moreover, because the ash content in fuel oil is very little, it will not be slagging on the convection heating surface, so the flue gas temperature at the furnace outlet can be as high as 1300 ℃, and the pitch between tubes on the convection heating surface can be reduced to increase the flue gas flow rate, thus the heat transfer coefficient on the heating surface can be increased. Save heating area and steel. In order to prevent spontaneous combustion of carbon black oil scale on economizers and air preheaters, steam soot blowers should be added to these parts to keep the heating surfaces clean. At the same time, because the fuel oil does not form coke slag, the membrane water-cooled wall can be used to form a micro-positive pressure (500 x 1000 cow / ml). A boiler. It can save the draft fan, only the fan can exhaust the flue gas out of the furnace. If the whole shell of the boiler is made of thick steel plate, it can also be made into a positive pressure (0.3 ~ 0.6 MPA) boiler, which can make the whole structure of the boiler more compact, and is more used in the gas-steam combined cycle generator set.

In most people's concept, the boiler is "silly, big, stupid, thick" representative. But in the fast boiler, but it will completely subvert the concept. When you first meet with the parties boiler fast, never thought the equipment was actually in front of a boiler. They look neat and clean, the overall design is very smooth, the boiler is also not "clumsy" shadow. Mr. Lu Haiqing Group Chairman, says: "Right now, we have four types of enterprises, more than 200 kinds boiler models, innovation and creativity we have tasted the sweetness." The face of fierce market competition, the fast side of the family must go deeply understand the creation of independent innovation road to seek greater development. We respond positively to national development strategies, investment in research on clean and environmentally friendly gas boiler, set up research cooperation with Tsinghua University base, development pattern of innovation and development of new products.

In order to prevent spontaneous combustion of carbon black oil scale accumulated on economizers and air preheaters, steam soot blowers should be added to these parts to keep the heating surfaces clean. At the same time, because the fuel oil does not form coke slag, membrane water-cooled wall can be used to form a micro-positive pressure boiler (500 x 1000 cow / m). It can save the draft fan, only the fan can exhaust the flue gas out of the furnace. If the whole shell of the boiler is made of thick steel plate, it can also be made into a positive pressure (0.3 ~ 0.6 MPA) boiler, which can make the whole structure of the boiler more compact, and is more used in the gas-steam combined cycle generator set.